Blogs

Kalimba Controller with piezo-resistive fabric pressure sensor for displacement measurement

This simple controller is inspired by the south African kalimba. The kalimba lends itself to rapid assembly because of its use of a single central bar held down by two screws to trap the array of tines between two pivot points.

Wooden tines are used in this prototype because they are faster to shape than the traditional metal and this controller doesn’t require the tines to be tuned. The flexibility of copper tape is exploited as strips follow the contour of the flat base around the curve of a half-round pressure pivot.

felt capacitive proximity sensing

a qprox demo board is used to demonstrate proximity sensing with e-textiles

Orientation

Are you feeling Red, Green or Blue?
Just orient this convex hexahedral cage to illumunate the color of your choice.
The lights flicker when you bang the table it is on (presumably the ball in the tilt switch bounces).

Dual Multitouch Pad with pressure

This controller demonstrates how most resistive touch screen systems can be modified to provide independent sensing of two positions on the surface. A single pressure measurement is also provided with a third sensing layer.

A pair of SlideWide sensors (http://infusionsystems.com) are stuck to each other at right angles.

Pressure Sensing Illuminated Button Array

Button array music controllers have a long history. I was fortunate to meet the late great, Salvatore Martirano who pioneered the construction of large button array music synthesizers. I saw him set up and play has Salmar Construction at IRCAM in the 1980's.

My modest contribution to this rich space is to enhance the illuminated button arrays (in this case from Sparkfun) with pressure sensitive resistive fabric.

Tablo etextile fabric drape sensing controller

This controller with no direct antecedents is made by draping conductive stretchable fabric over a cereal bowl creating a curve related to the famous one called the witch [sic] of Agnesi.
Resistive strips around the bowl are shorted out by the fabric and the varying resistances are
measured and sent via USB to control software on a host computer.

OSCuino rough Arduino OSC sketch for Open Sound Control work

This example uses the recommended OSC SLIP wrapping for OSC serial messages. Attached is an example Max/MSP patch to display the OSC messages which represent the pin states, temperature and power supply voltages. You may need slipOSC from the CNMAT downloads page to unwrap the USB serial OSC. This is a simple introduction to building OSC messages. Yotam Mann has built a complete library for Arduino that does the full OSC protocol It is available from CNMAT. This example uses the recommended OSC SLIP wrapping for OSC serial messages. Attached is an example Max/MSP patch to display the OSC messages which represent the pin states, temperature and power supply voltages. You may need slipOSC from the CNMAT downloads page to unwrap the USB serial OSC. This is a simple introduction to building OSC messages. Yotam Mann has built a complete library for Arduino that does the full OSC protocol It is available from CNMAT.
/*
 * OSCuino Rough
 * Copyright 2009 Adrian Freed.  

Augmented Electric Guitar

Experimental surface sensing for fingerstyle players

Better Arduino alternatives

I don't use the stock "official" Arduino boards for my work. The $18 teensy 2.0 is smaller than any of the stock Arduinos, has more A/D pins than any of them except the Mega, has more memory, more PWM pins, full speed USB serial support and has a more accurate crystal cock instead of a resonator.

Syndicate content